Daily $450Weekly $1350
Our Complete Set is a 3 motor and camera control set accompanied with a multi – functional touch screen display. The set can assume hard – wired, and wireless, control of up to three motors; it can also assume control of the camera and camera functions.
The display reads out lens information and can control the camera: camera speed, shutter and “camera run”. The camcon software module includes programs which can control camera settings ( camcon ) and can program and execute ramps ( cramp ). The set includes a hand unit to control both the focus and the iris, a zoom extension unit and a zoom handle. Three motors are included in the set. The set includes all cables, all fastening tools and all necessary accessories including six batteries and two chargers. The set includes a wireless module ( cdisplay.ext ) so the cdisplay can be used in wireless mode. It can also be used in hard – wired mode. The set also includes a reader/ writer for ctags. Cmotion can also be used on most 3D rigs.
Ergonomic design Cmotion invested a lot of time in the development phase to insure the best and most efficient design possible was achieved. cmotion was focused on developing a LCS offering a completely new, innovative and ergonomic design, based on customer requirements. The system's light-weight and ergonomics makes working with it a pleasure. Modular & multi-functional The modularity of the system makes it possible for the user to control the focus, iris and zoom motors in one single hand unit or control can be shared among various hand units, in various configurations between numerous users. You have the choice of working hardwired or wireless. Our system can be expanded easily; you can start with a small system (e.g. with a focus control system) and upgrade at anytime.
User friendly We would also like to point out the system's user interface. It has been designed to be easily understood, therefore easy to use.
The set includes the following:
1 x C-amin (The brain of the system)1 x C-operate (The Hand Held or Control Unit)1 x C-Display Set (Full touch screen LCD Panel)1 x C-zoom Set Zoom + Chandle (All in one Zoom Control)1 x Cfastner (Universal clamp for rods from 15-28mm with 1/4" thread1 x Cfast-czoom (Fastner-set for czoom and czoom II)1 x Cfast-camin (Fastner for camin)1 x Ctruss (fastner for coperate)3 x Heden M26VE Motors6 x Batteries1 x Charger12 x Marker RingsThe set includes all cables, all fastening tools and all necessary accessories. The set includes a wireless module ( cdisplay.ext ) so the cdisplay can be used in wireless mode. It can also be used in hard wired mode. The set also includes a reader/ writer for ctags . This system is a multi user system which can be controlled by various users, in various wireless/ hard wired combinations, adding to its total modularity. (e.g. Zoom control, focus pulling and camera control can be distributed between two assistants and the DP)
3 Motor Packing List